| Research Interest : Multi-media Source Compression |
| Channel Coding | Multiple Access, Modulation and Transceivers | Wireless Networking | Software Defined Radio | Main Page |
Research topic:
| Wideband speech coding for mobile communications
Hee Thong How |
|
Wideband speech coding is of increasing interest today and it is intended for compressing speech or audio signals of 7 kHz bandwidth, sampled at 16 kHz. As shown in Figure \ref{wideband_spectrum}, extending the lower frequency range down to 50 Hz from the 300 Hz lower boundary of narrowband codecs increases naturalness, presence and comfort. At the high end of the spectrum, extending the higher frequency range to 7000 Hz increases intelligibility and makes it easier to differentiate between fricative sounds. This results in an improved speech quality, which will find applications in videoconferencing, loudspeaker telephony and high-definition television.
Figure 1 : Typical energy spectrum of a wideband speech signal.
Hee Thong's research is considering various techniques of coding wideband
speech at bit rates between 8 and 32 kbit/s. These techniques include the
state-of-the-art Code Excited Linear Prediction (CELP) algorithms, which
have been applied successfully in narrowband speech coding. Both forward-
and backward-adaptive CELP schemes were investigated. Currently, we are
investigating the feasibililty of employing sinusoidal transform coding
(STC) techniques in wideband speech coding. It is also of interest to study
the application of the wavelet transform in the context of wideband speech
coding, especially in the intermediate bit rate range between 16 and 64
kbit/s, where the computational complexity of CELP codecs becomes excessive.
|
Most of the existing standard video codecs were designed for achieving
high compression ratios of up-to 400:1. This is generally achieved by transmitting
only the 'difference' between consecutive video frames, and using techniques
such as run-length
and Huffman coding for removing the predictable information. However,
if some information is lost or corrupted, the decoder can misinterpret
the following data, inflicting artifacts, which may persist for several
seconds. Alternatively, if the difference between two consecutive video
frames was someone moving their hand, and this information is lost, the
decoded video could show an additional hand floating in the air', and again,
the effects could last for several seconds. In order to recover from artifacts
the video encoder regularly transmits certain video frame in full, without
motion prediction, which are referred to as INTRA-coded frames. However,
transmitting a video frame in full -without motion prediction - requires
more bits, than transmitting the video scene 'changes' since the last frame,
and hence in low bitrate applications the number of INTRA-coded frames
is limited, which extends the time that artifacts appear for. However,
if some of the INTRA-coded frames are lost or corrupted, then the decoded
video could be worse rather than better following a corrupted INTRA-coded
frame.
The simplest solution for protecting the video information is to use powerful error-correction coding, in order to improve the robustness against transmission errors. However, this technique has some disadvantages, since strong error correction can severely reduce the available bitrate for the video codec and reduce the video quality. If the error correction scheme is designed to cope with short periods of total signal loss, then the error correction can add significant delay to the video system, which may cause the video to appear jerky, and may lead to the loss of synchronisation with the associated audio information.
The best solution is to use error correction coding in conjunction with other techniques, in order to overcome short periods of total signal loss. During my PhD we investigated how we could improve the robustness of two standard video codecs, namely that of the H.261 and H.263 schemes. We designed a system, which we found to be robust to lost information and errors. The system divided the encoded information of the video codec into packets and if the packet was corrupted or failed to arrive at the decoder, then the decoder signalled this to the encoder, which provided a feedback to the video codec encoder, in order to ensure that the information from corrupted packets was retransmitted in later video frames. In order that these retransmissions did not increase the bitrate, the video packetiser was arranged to control the bitrate of the video codec to ensure that the bitrate remained constant. The performance of this intelligent packetisation scheme can be judged from the example shown in Figure~\ref{fig:peter1}.
Figure 2 :This is an example of our error resilient packet video
system which shows four consecutive video frames. The network has corrupted
some of the transmitted packets, resulting in part of the video image to
become frozen, as shown in frames 26 and 27. However, the system soon recovers,
and replenishes the affected areas, as shown in frame 28. When these video
frames are shown at the full speed of 10 frames per second, the loss of
the packets is almost undetectable.
\label{fig:peter1}
During his PhD Peter also investigated various network techniques for improving the performance of packet video systems. A particularly effective technique was using multi-mode modulation transceivers. These transceiver are capable of reconfiguring themselves in response to time-variant channel conditions. For example, when the signal strength is poor, a more robust but lower bitrate modulation scheme is used. However, when the signal strength is strong, since the mobile receiver is close to the transmitter, the transceiver can switch to a higher-order modulation scheme, which supports a significantly higher bitrate, providing for either higher quality video telephony, or higher bitrate internet access.
Upon completing his PhD, Peter joined an industrial project funded by the UK's Virtual Centre of Excellence in Mobile and Personal Communications - in short the Mobile VCE. It is a collaborative partnership between about 25 of the world's most prominent Mobile Communications companies and seven UK Universities, each having long standing specialist expertise in relevant areas. Its formation was endorsed by the Department of Trade and Industry.
The Communications group was awarded funding to conduct research in Intelligent Wireless Video Communications under the auspices of the Terminals Working Group in the Mobile VCE.
Every three months all the academic partners and representatives from
some of the Industrial sponsers meet to discuss the progress of the research.
This provides invaluable industrial feedback for our research, and often
opens up new areas of research based on these discussions.
[top]